electronic silicone potting compound silicone potting compound electrically insulating potting compound

? Two components silicone potting compound ? Widly used in LED power driver and solar PV junction box ? With good thermal conductivity ,UL94v-0 ? UL,REACH,RoHS certificates Mainly used in LED power driver and solar PV junction box as potting compound

Haoming is a leading chinese manufacturer for onecomponent and two components silicone sealant ,which are widly used in craft,LED,Solar PV ,consumer electronics ,automobile,etc.Our products includesilicone rubber, RTV-2 mold making silicone, RTV liquid silicone rubber,thermalconductive silicone potting compound,electronic silicone conformalcoating,silicone encapsulant,electronic silicone sealant,general purposeneutral silicone sealant,gasket silicone sealant .For more information aboutour silicone sealant ,pls contact Mandy Hong marketing1@hm-sil.com   www.homeen-sil.com www.haomingsilicone.com

HM-9160Product Information

Features：

Room temperature cure or rapid hot cure., solvent-free orbyproduct-free ,limited contractility ;

Flame retardant.

Excellent thermal conductive property and dielectricproperty.

Stable and flexible from -50℃to 200℃.

Typical properties:

Note: thisproduct is affected by the temperature , the higher the temperature, shorteroperation time and shorter curing time

Mixing

The two components should be thoroughly mixed using aweight or volume ratio of 1:1 until the mixture has a uniform color.To makesure the mixture is even,suggest that agitate per A and B respectively beforemixing up.Pour the complete mixed material into the target potting side,normally you don’t need to use vacuum to release the bubble, but if high thermalconductivity is needed,suggest that use vacuum at -0.08MPa or above, release thebubble under vacuum environment for about 5-10min first then apply the potting.

Attention:

1, This produce cure with the help ofcatalyst platinum, sulfide, nitrogen, sulfur, phosphorus and organic tincompound may inhibit curing process .We suggest that before applying ourproduct ,pls clean the residue of rosin on circuit board and try use low leadsolder.

 electronic silicone potting compound silicone potting compound electrically insulating potting compound
2, choose the room temperature curing process, it is suggested that let themixture sit still for more than 60 mins to release the bubble before applyingin order to obtain the best performances.
3, select heating curing process, it is suggested that the vacuum deaeration,then filling, heat curing, to obtain the best performance.
4, avoid direct contact with epoxy adhesive, polyurethane adhesive,condensation silicone ,which could affect the curing process .

5, should be carried out perfusion within theoperating time , base material or electronic components surface should be cleanand dry before perfusion .
6, this product is a  non-dangerousgoods, but forbid to direct contact with mouth and eyes .

Usable life and storage

Base A and curing agent B has a shelf life of9 months from the date of manufacture respectively. Pls completely mix the A and B separately beforeuse.